Nissan Sentra manuals

Nissan Sentra Service Manual: Removal and installation

Push-button ignition switch

Removal and installation

Removal

  1. Remove the nats antenna amp. Refer to sec-135, "removal and installation"
  2. Remove the push-button ignition switch.

Installation

Installation is in the reverse order of removal.

Symptom diagnosis
Push-button ignition switch does not operate Description Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom. N ...

Charging system
...

Other materials:

Parking brake
WARNING Be sure the parking brake is fully released before driving. Failure to do so can cause brake failure and lead to an accident. Do not release the parking brake from outside the vehicle. Do not use the shift lever in place of the parking brake. When parki ...

Refrigerant
Description CONNECTION OF SERVICE TOOLS AND EQUIPMENT Shut-off valve A/C service valve Recovery/recycling/recharging equipment Refrigerant container (HFC-134a) Weight scale (J-39650) Vacuum pump (J-39649) Manifold gauge set (J-39183) Preferred (best) method Alternativ ...

Precaution for Liquid Gasket
Removal of liquid gasket After removing the bolts and nuts, separate the mating surface and remove the old liquid gasket using tool. Tool number : kv10111100 (j-37228) Caution: Do not damage the mating surfaces. Tap the seal cutter to insert it (1). In areas where the tool is diffic ...

© 2014-2026 Copyright www.nisentra.com