Nissan Sentra manuals

Nissan Sentra Service Manual: Removal and installation

Front fog lamp
Aiming adjustment PREPARATION BEFORE ADJUSTING The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb. Before performing aiming adjustment procedure, check the following: ...

Front combination lamp
Exploded view Large cover (not serviceable) Small cover (not serviceable) Front combination lamp Halogen lamp bulb (high beam) Turn signal lamp bulb Turn signal lamp bulb socket ...

Other materials:

Power window and door lock/unlock switch RH
Removal and Installation REMOVAL Release the pawls using a suitable tool and lift the power window and door lock/unlock switch RH and finisher as an assembly and remove. Disconnect the harness connector from the power window and door lock/unlock switch RH. Release the four pawls (tw ...

Removal and installation
Ipdm e/r Exploded view Ipdm e/r IPDM E/R cover A Ipdm e/r cover b Removal and installation Caution: Ipdm e/r integrated relays are not serviceable and must not be removed from unit. Removal Remove inlet air duct (upper). Refer to em-25, "removal and installation" ...

P050A, P050B, P050E Cold start control
Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P050A, P050B or P050E ...

В© 2014-2026 Copyright www.nisentra.com