Nissan Sentra Service Manual: Removal and installation

Squeak and rattle trouble diagnoses

Work Flow Customer interview Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the diagnostic worksheet during the interview to document th ...

Glass lid

Exploded view Glass lid Roof panel Front Removal and installation Removal Caution: After installing glass lid, check gap/height adjustments and operation to make sure there is ...

Other materials:

Throttle valve closed position learning
Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time the harness connector of the electric throttle control actuator or ECM is ...

Dtc/circuit diagnosis
Power supply and ground circuit Diagnosis Procedure Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description". Vehicle security indicator Description DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Con ...

Low tire pressure warning lamp
Component Function Check 1.CHECK THE ILLUMINATION OF THE LOW TIRE PRESSURE WARNING LAMP Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is turned ON. Is the inspection result normal? YES >> Inspection ...