Nissan Sentra Service Manual: Removal and installation

Power window lock switch does not function

Diagnosis Procedure 1.REPLACE POWER WINDOW MAIN SWITCH Replace power window main switch. Confirm the operation after replacement. Is the result normal? YES >> INSPECTION END NO >& ...

Main power window and door lock/ unlock switch

Removal and Installation REMOVAL Release the pawls using a suitable tool and lift the main power window and door lock/unlock switch and finisher as an assembly and remove. Disconnect the h ...

Other materials:

Fuel injector
Component Function Check 1.INSPECTION START Turn ignition switch to START. Is any cylinder ignited? YES >> GO TO 2. NO >> Proceed to EC-450, "Diagnosis Procedure". 2.CHECK FUEL INJECTOR FUNCTION With CONSULT Start engine. Perform “POWER BALANCE” in Р...

Push-Button Ignition Switch (if so equipped)
WARNINGDo not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed 3 consecutive times in quick succession or the ignition switch is pushed and held for more than 2 seconds.) If ...

P0447 EVAP Canister vent control valve
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0447 VENT CONTROL VALVE (Evaporative emission system vent control circuit open) An improper voltage signal is sent to ECM throug ...