Nissan Sentra Service Manual: Removal and installation
Nats antenna amp
Removal and installation
Removal
- Remove instrument finisher b. Refer to ip-14, "exploded view".
- Using a suitable tool release the pawls on either side and remove the NATS antenna amp. from the pushbutton ignition switch.
Installation
Installation is in the reverse order of removal.
Push-button ignition switch
Removal and installation
Removal
- Remove the NATS antenna amp. Refer to SEC-135, "Removal and Installation".
- Using a suitable tool release the pawls and remove the push-button ignition switch from instrument finisher b.
Installation
Installation is in the reverse order of removal.
Symptom diagnosis
Engine does not start when intelligent key is inside of vehicle
Description
Engine does not start when push-button ignition switch is pressed while
carrying intelligent key.
Note:
Check that ...
Other materials:
Intake manifold runner control
INTAKE MANIFOLD RUNNER CONTROL : System
Description
SYSTEM DIAGRAM
SYSTEM DESCRIPTION
Intake manifold runner control valve has a valve portion in the intake
passage of each cylinder.
While idling and during low engine coolant temperature, the intake manifold
runner control valve close ...
A-bag branch line circuit
Diagnosis procedure
Warning:
Always observe the following items for preventing accidental
activation.
Before servicing, turn ignition switch off, disconnect battery
negative terminal, and wait 3 minutes
or more. (To discharge backup capacitor.)
Never use unspecified tester or other me ...
AM radio reception
AM signals, because of their low frequency, can
bend around objects and skip along the ground.
In addition, the signals can be bounced off the
ionosphere and bent back to earth. Because of
these characteristics, AM signals are also subject
to interference as they travel from transmitter
to r ...
