Nissan Sentra manuals

Nissan Sentra Service Manual: Removal and installation

Performance test
Inspection INSPECTION PROCEDURE Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold gauge. Start the engine, and set to the following condition. Test condition ...

Compressor
Exploded view With air conditioning Compressor Front Without air conditioning A/c idler pulley A/c idler pulley bracket Compressor Compressor : removal and installation REM ...

Other materials:

P0452 EVAP Control system pressure sensor
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0452 EVAP SYS PRES SEN (Evaporative emission system pressure sensor/switch low) An excessively low voltage from the sensor is se ...

General Precautions
Always use a 12 volt battery as power source. Do not attempt to disconnect battery cables while engine is running. Before connecting or disconnecting the ECM harness connector, turn ignition switch OFF and disconnect negative battery cable. Failure to do so may damage the ECM because ...

Precaution
Precaution for supplemental restraint system (srs) "air bag" and "seat belt pre-tensioner" The supplemental restraint system such as “air bag” and “seat belt pre-tensioner”, used along with a front seat belt, helps to reduce the risk or severity of injur ...

© 2014-2026 Copyright www.nisentra.com