Nissan Sentra Service Manual: Removal and installation

System description

In-cabin microfilter Description FUNCTION Air inside the passenger compartment is kept clean at either recirculation or fresh mode by installing an in-cabin microfilter into the heating and cooli ...

Ducts and grilles

Exploded View Heating and cooling unit assembly Center ventilator duct Defroster duct Side ventilator duct (LH) Front floor duct (LH) Rear floor connecting duct (LH) Rear floor duc ...

Other materials:

Slip indicator lamp
Component Function Check 1.CHECK SLIP INDICATOR LAMP FUNCTION Check that slip indicator lamp in combination meter turns ON for approximately 2 seconds after ignition switch is turned ON. Is the inspection result normal? YES >> Inspection End. NO >> Proceed to diagnosis proce ...

Installing front license plate
Use the following steps to mount the front license plate: Make holes on the plastic finisher at the location mark (small dimple) using a 0.20 in (5 mm) drill. Apply light pressure to the drill. Install the license plate holder using the two screws provided with the holder. Mount ...

Ipdm-e branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the ipdm e/r for damage, bend and loose connection (unit side and connector side). Is the inspection result normal? Yes ...