Nissan Sentra Owners Manual: RearView Monitor (if so equipped)

Nissan Sentra Owners Manual / Monitor, climate, audio, phone and voice recognition systems / RearView Monitor (if so equipped)

When the shift lever is shifted into the R (Reverse) position, the monitor display shows the view to the rear of the vehicle.

WARNING

Failure to follow the warnings and instructions for proper use of the RearView Monitor could result in serious injury or death.

The RearView Monitor is a convenience but it is not a substitute for proper backing.

Always turn and look out the windows, and check mirrors to be sure that it is safe to move before operating the vehicle. Always back up slowly.
The system is designed as an aid to the driver in showing large stationary objects directly behind the vehicle, to help avoid damaging the vehicle.
The system cannot completely eliminate blind spots and may not show every object.
Underneath the bumper and the corner areas of the bumper cannot be viewed on the RearView Monitor because of its monitoring range limitation. The system will not show small objects below the bumper, and may not show objects close to the bumper or on the ground.
Objects viewed in the RearView Monitor differ from actual distance because a wide-angle lens is used.
Objects in a RearView Monitor will appear visually opposite than when viewed in the rear view and outside mirrors.
Make sure that the trunk is securely closed when backing up.
Do not put anything on the rearview camera. The rearview camera is installed above the license plate.
When washing the vehicle with high pressure water, be sure not to spray it around the camera. Otherwise, water may enter the camera unit causing water condensation on the lens, a malfunction, fire or an electric shock.
Do not strike the camera. It is a precision instrument. Otherwise, it may malfunction or cause damage resulting in a fire or an electric shock.

CAUTION

There is a plastic cover over the camera.

Do not scratch the cover when cleaning dirt or snow from the cover.

How to use the APPS – i button

For more information about the “SiriusXM Travel Link”, and “SiriusXM Traffic” features, see the separate Navigation System Owner’s Manual. For more information about the “My App ...

How to read the displayed lines

Guiding lines which indicate the vehicle width and distances to objects with reference to the vehicle body line A are displayed on the monitor. Distance guide lines: Indicate distances from th ...

Other materials:

Emission control information label
The emission control information label is attached to the underside of the hood as shown. Tire and loading information label The cold tire pressure is shown on the Tire and Loading Information label. The label is located as shown. Air conditioner specification label The air condit ...

P050A, P050B, P050E Cold start control
Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P050A, P050B or P050E ...

P0137 HO2S2
DTC Logic DTC DETECTION LOGIC The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time. To judge the malfunctions of heated oxygen ...