Nissan Sentra manuals

Nissan Sentra Service Manual: Rear window defogger relay

Description

Power is supplied to the rear window defogger with BCM control.

Component Function Check

1. Check rear window defogger relay power supply circuit

  1. Turn ignition switch ON.
  2. Check that an operation noise of rear window defogger relay (located in IPDM E/R) can be heard when turning the rear window defogger switch ON.

Is the inspection result normal? Yes >> rear window defogger relay power supply circuit is ok.

No >> refer to def-32, "diagnosis procedure".

Diagnosis Procedure

Regarding wiring diagram information, refer to def-20, "wiring diagram".

1.Check fuses

Check if any of the following fuses in the ipdm e/r are blown.

Is the inspection result normal?


Is the inspection result normal? Yes >> go to 2

No >> replace the fuse after repairing the affected circuit.

2. Check rear window defogger relay power supply circuit

  1. Turn ignition switch on.
  2. Check voltage between IPDM E/R connector E48 terminal 62 and ground.

Is the inspection result normal?


Is the inspection result normal? Yes >> go to 3

No >> replace ipdm e/r. Refer to pcs-30, "removal and installation" (with intelligent key system) or pcs-58, "removal and installation" (without intelligent key system).

3. Check intermittent incident

Check intermittent incident.

Refer to gi-39, "intermittent incident" is the inspection result normal? Yes >> check the following:

No >> repair or replace the malfunctioning parts.

Rear window defogger switch
Description The rear window defogger is operated by pressing the rear window defogger switch ON. The indicator lamp in the rear window defogger switch illuminates while the rear window def ...

Rear window defogger power supply and ground circuit
Description Heats the heating wire with the power supply from the rear window defogger relay to prevent the rear window from fogging up. Component function check 1. Check rear window defogger ...

Other materials:

Continuously Variable Transmission (CVT) (if so equipped)
The ignition lock is designed so that the ignition switch cannot be turned to the LOCK position until the shift lever is moved to the P (Park) position. When moving the ignition switch to the LOCK position, make sure the shift lever is in the P (Park) position. When removing the key ...

Ecu diagnosis information
Abs actuator and electric unit (control unit) Reference Value VALUES ON THE DIAGNOSIS TOOL CAUTION: The display shows the control unit calculation data, so a normal value might be displayed even in the event the output circuit (harness) is open or short-circuited. ...

Trunk room lamp circuit
Description Controls the trunk room lamp (ground side) to turn the trunk room lamp on and off. Diagnosis Procedure Regarding wiring diagram information, refer to inl-17, "wiring diagram". Caution: Before performing the diagnosis, check that the following are normal. Interior roo ...

В© 2014-2022 Copyright www.nisentra.com