Description
Heats the heating wire with the power supply from the rear window defogger relay to prevent the rear window from fogging up.
Component function check
1. Check rear window defogger
Check that the heating wire of rear window defogger is heated when turning the rear window defogger switch on.
Is the inspection result normal? Yes >> rear window defogger is ok.
No >> refer to def-33, "diagnosis procedure".
Diagnosis procedure
Regarding wiring diagram information, refer to def-20, "wiring diagram".
1. Check fuses
Check if any of the following fuses in IPDM E/R are blown.
Is the inspection result normal? Yes >> go to 2.
No >> replace the blown fuse after repairing the affected circuit.
2. Check rear window defogger power supply circuit
Is the inspection result normal? YES >> GO TO 3.
NO >> Perform rear window defogger relay diagnosis. Refer to DEF-32, "Diagnosis Procedure".
3. Check power supply circuit
Is the inspection result normal? YES >> GO TO 4.
NO >> GO TO 5.
4. Check ground circuit
Is the inspection result normal? YES >> GO TO 6.
NO >> Repair or replace harness.
5. Check harness continuity
Is the inspection result normal? Yes >> replace condenser. Refer to def-49, "removal and installation".
No >> replace or repair harness.
6. Check filament
Check filament.
Refer to DEF-34, "Component Inspection".
Is the inspection result normal? YES >> Refer to GI-39, "Intermittent Incident".
NO >> Repair filament. Refer to DEF-47, "Inspection and Repair".
Component inspection
1. Check filament
Check the filament for damage or open circuits.
Refer to DEF-47, "Inspection and Repair".
Is the inspection result normal? YES >> Inspection End.
NO >> Repair filament. Refer to DEF-47, "Inspection and Repair".
U1000 CAN Comm circuit
Description
Can (controller area network) is a serial communication line for
real time application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent error
detection ability. Many electronic
control units are equipped onto a vehicle, and each co ...
P0131 A/F Sensor 1
DTC Logic
DTC DETECTION LOGIC
To judge the malfunction, the diagnosis checks that the A/F signal computed
by ECM from the A/F sensor 1
signal is not inordinately low.
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P01 ...
Engine coolant temperature gauge
NOTE:
The ignition switch must be placed in the
ON position for the gauge to give a reading.
The gauge indicates the engine coolant temperature.
The engine coolant temperature is within the
normal range when the reading is within the zone
A shown in the illustration.
The engine coolan ...