Nissan Sentra manuals

Nissan Sentra Service Manual: Rear suspension assembly

Inspection

COMPONENT PART

Check the mounting conditions (looseness, backlash) of each component. Verify the component conditions (wear, damage) are normal.

SHOCK ABSORBER

Check the shock absorber for oil leaks or damage. Replace the components if necessary.

Periodic maintenance
...

Wheel alignment
Inspection DESCRIPTION Measure the wheel alignment under unladen conditions. NOTE: “Unladen conditions” means that fuel, engine coolant, and lubricants are full. Spare tire, jack, hand ...

Other materials:

General Precautions
Always use a 12 volt battery as power source. Do not attempt to disconnect battery cables while engine is running. Before connecting or disconnecting the ECM harness connector, turn ignition switch OFF and disconnect negative battery cable. Failure to do so may damage the ECM because ...

P1800 Intake manifold tuning valve
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P1800 VIAS S/V-1 (Variable intake air system control solenoid valve-1) An excessively low or high voltage signal is sent to ECM t ...

Positive crankcase ventilation
Inspection 1.CHECK PCV VALVE With engine running at idle, remove PCV valve from rocker cover. A properly working valve makes a hissing noise as air passes through it. A strong vacuum should be felt immediately when a finger is placed over valve inlet. Is the inspection result normal? YES &g ...

© 2014-2026 Copyright www.nisentra.com