Nissan Sentra Service Manual: Rear suspension

Service data and specifications (SDS)

Wheel Alignment (Unladen*1) UNITED STATES and CANADA *1: Fuel, engine coolant, and lubricants are full. Spare tire, jack, hand tools, and mats are in designated positions. *2: The difference ...

Precaution

...

Other materials:

Dtc/circuit diagnosis
Power supply and ground circuit Diagnosis Procedure Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description". Vehicle security indicator Description DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Con ...

Oil seal
Valve oil seal : Removal and Installation REMOVAL Rotate crankshaft, and set piston whose valve oil seal is to be removed to TDC. This will prevent valve from dropping into cylinder. CAUTION: When rotating crankshaft, be careful to avoid scarring front cover with timing chain. Re ...

Condenser
Removal and installation Removal Remove the rear pillar finisher. Refer to INT-29, "REAR PILLAR FINISHER : Removal and Installation". Disconnect the harness connectors (1), remove the condenser bolt (A) and the condenser (2). : Front Installation Installation is in th ...