Nissan Sentra Service Manual: Rear drum brake
BRAKE LINING
BRAKE LINING : Inspection
INSPECTION
Brake Lining
- Check brake lining wear thickness (A). Check using a scale if necessary.
Lining wear thickness (A) : Refer to BR-55, "Rear Drum Brake".
BRAKE DRUM
BRAKE DRUM : Inspection
INSPECTION
Appearance
Check surface of brake drum for uneven wear, cracks and serious damage. Replace it if necessary. Refer to BR-42, "Removal and Installation".
Brake Drum Inner Diameter
Check inner diameter (B) of the brake drum using suitable tool.
Brake drum inner diameter (B) : Refer to BR-55, "Rear Drum Brake".
Front disc brake
BRAKE PAD
BRAKE PAD : Inspection
PAD WEAR
Check brake pad thickness from an inspection hole on caliper body.
Check using a scale if necessary
Wear limit thickness : Refer to BR-55, "Front ...
Rear disc brake
BRAKE PAD
BRAKE PAD : Inspection
PAD WEAR
Check pad thickness from an inspection hole on caliper body. Check
using a scale if necessary.
Wear limit thickness : Refer to BR-55, "Rear Disc
Br ...
Other materials:
P0127 IATSensor
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0127
IAT SENSOR-B1
(Intake air temperature too high)
Rationally incorrect voltage from the sensor is
sent to ECM, compared with the ...
Environmental factors influence the rate of corrosion
Moisture
Accumulation of sand, dirt and water on the vehicle
body underside can accelerate corrosion.
Wet floor coverings will not dry completely inside
the vehicle and should be removed for drying to
avoid floor panel corrosion.
Relative humidity
Corrosion will be accelerated in areas of h ...
Rear air spoiler
Removal and installation
Rear air spoiler
High mounted stop lamp connector
(if equipped)
Trunk lid
Grommet
Nut
Front
Removal
Remove trunk lid finisher. Refer to INT-45, "Removal and Installation".
Disconnect the harness connector from the high mounted stop ...
