Nissan Sentra Service Manual: Rear door finisher
Exploded View
- Rear door panel
- Rear door finisher
- Inside door handle escutcheon
- Rear power window switch finisher
- Grommet
Clip
Pawl
Front
Removal and Installation
CAUTION:
- When removing, always use a suitable tool that is made of plastic
to prevent damage to the parts.
- Do not damage the door panel.
REMOVAL
- Remove inside door handle escutcheon.
- Apply protective tape (A) to protect the component from damage
as shown.
- Insert a suitable tool (A) as shown between inside door handle
escutcheon and inside door handle.
- With suitable tool (A) in position, insert a second suitable tool (B)
as shown, then release pawl as shown.
Pawl
- Pull upward on the inside door handle escutcheon as shown to
release the pawls on the upper portion of inside door handle
escutcheon.
Pawl
- Press down on the inside door handle escutcheon as shown to
release the pawls on the lower portion of inside door handle
escutcheon.
Pawl
- Insert a suitable tool (A) as shown to release the remaining pawl
and remove.
Pawl
- Remove rear power window switch finisher. Refer to PWC-72, "Removal and
Installation".
- Remove rear door finisher.
- Remove rear door finisher screw (A).
- Apply protective tape (A) to protect the component from damage
as shown.
- Release rear door finisher clips using a suitable tool (A) as
shown.
Clip
Remove rear door finisher as shown.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
When installing, check that clips are accurately aligned with the holes
on the door panel, then press in.
Exploded View
Front door panel
Front door finisher
Inside door handle escutcheon
Main power window and door lock/
unlock switch finisher
Door mirror corner finisher
Grommet
...
Exploded View
Rear body side welt
Front body side welt
Tether clip
Front pillar finisher
Metal clip
Dash clip
Dash side finisher
Harness protector
Front kicking plate inner
C ...
Other materials:
Inside key antenna
Console
CONSOLE : Removal and Installation
REMOVAL
Remove the shift selector finisher. Refer to IP-17, "Removal and
Installation".
Remove the inside key antenna (console) screws (A) and inside
key antenna (console) (1).
INSTALLATION
Installation is in the reverse order ...
Control cable
Exploded View
Control cable
Lock plate
Transaxle assembly
Bracket A
Bracket B
CVT shift selector assembly
Manual lever
Grommet
Removal and Installation
INSTALLATION
CAUTION:
Always apply the parking brake before performing removal and
installation.
Apply the p ...
Measurement of weights
Secure loose items to prevent weight
shifts that could affect the balance of your
vehicle. When the vehicle is loaded, drive
to a scale and weigh the front and the rear
wheels separately to determine axle
loads. Individual axle loads should not exceed
either of the gross axle weight ratings
( ...
В© 2014-2024 Copyright www.nisentra.com