Nissan Sentra Service Manual: Rear disc brake
Exploded View
- Sliding pin bolt
- Bushing
- Cap
- Bleeder valve
- Cylinder body
- Piston seal
- Piston
- Piston boot
- Sliding pin boot
- Torque member
Apply rubber grease
Apply brake fluid
Disassembly and Assembly
DISASSEMBLY
- Place a wooden block as shown, and blow air from union bolt hole to remove piston and piston boot.
WARNING:
Do not get fingers caught between piston and cylinder body.
- Remove piston seal from cylinder body using suitable tool.
CAUTION:
Do not damage cylinder inner wall.
- Remove bleeder valve and cap.
ASSEMBLY
- Install bleeder valve and cap.
- Apply rubber grease to piston seal (1), and install to cylinder body.
CAUTION:
Do not reuse piston seal.
- Apply rubber grease to piston boot (1). Cover the piston (2) end with piston boot, and install cylinder side lip on piston boot securely into a groove on cylinder body.
CAUTION:
Do not reuse piston boot.
- Apply new brake fluid to piston (1). Push piston into cylinder body by hand and push piston boot (2) piston-side lip into the piston groove.
CAUTION:
Press the piston evenly and vary the pressing point to prevent cylinder inner wall from being rubbed.
Rear drum brake
Exploded View
Cap
Bleeder valve
Piston
Spring
Boot
Piston cup
Wheel cylinder
Apply rubber grease
Apply PBC (Poly Butyl Cuprysil)
grease or silicone-based grease
Apply ...
Service data and specifications (SDS)
General Specifications
Brake Pedal
Check Valve
Brake Booster
Front Disc Brake
Rear Drum Brake
Rear Disc Brake
...
Other materials:
Strg branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the steering angle sensor for
damage, bend and loose connection
(unit side and connector side).
Is the inspection result ...
Brake master cylinder
Inspection
Check for brake fluid leakage at the following areas:
Master cylinder mounting face
Reservoir tank mounting face
Brake tube and brake tube connections
Brake hose and brake hose connections
If any brake fluid leakage is found, repair as necessary.
On Board Inspection
LEAK ...
Air flow charts
The following charts show the button and dial
positions for MAXIMUM AND QUICK heating,
cooling or defrosting. The air recirculation
button should always be in the OFF position
for heating and defrosting.
...
