Nissan Sentra manuals

Nissan Sentra Service Manual: Rear combination lamp

Exploded View


  1. Rear combination lamp
  2. Rear turn signal lamp bulb
  3. Rear turn signal lamp socket
  4. LED lamp harness connector
  5. Rear combination lamp harness connector
  6. Back-up lamp bulb socket
  7. Back-up lamp bulb

Disassembly and Assembly

DISASSEMBLY

WARNING:

Do not touch bulb while it is lit or right after being turned off. Burning may result.

CAUTION:

  1. Remove rear combination lamp. Refer to EXL-126, "Removal and Installation".
  2. Rotate rear turn signal lamp bulb socket counterclockwise to remove from rear combination lamp.
  3. Remove the rear turn signal lamp bulb from bulb socket.
  4. Rotate back-up lamp bulb socket counterclockwise to remove from rear combination lamp.
  5. Remove the back-up lamp bulb from bulb socket
  6. Disconnect the harness connector from the LED lamp.

ASSEMBLY

Assembly is in the reverse order of disassembly.

CAUTION:

After installing, be sure to install the bulb sockets securely to ensure watertightness.

Revision:

Front combination lamp
Exploded View Large cover (not serviceable) Small cover (not serviceable) Front combination lamp Halogen lamp bulb (high beam) Turn signal lamp bulb Turn signal lamp bulb socket LE ...

Service data and specifications (SDS)
Bulb specifications *: Always check with the Parts Department for the latest parts information. ...

Other materials:

Eps branch line circuit
Diagnosis Procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the eps control unit for damage, bend and loose connection (unit side and connector side). Is the inspection result norm ...

P2096, P2097 A/F Sensor 1
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible Cause P2096 POST CAT FUEL TRIM SYS B1 (Post catalyst fuel trim system too lean bank 1) The output voltage computed by ECM from the A/F ...

Both side headlamps do not switch to high beam
Description The headlamps (both sides) do not switch to high beam when the lighting switch is in the hi or pass setting. Diagnosis procedure 1.Combination switch (lighting and turn signal switch) inspection Check the combination switch (lighting and turn signal switch). Refer to bcs-72, &q ...

В© 2014-2024 Copyright www.nisentra.com