Nissan Sentra Service Manual: Rear combination lamp
Exploded view
- Rear combination lamp
- Rear turn signal lamp bulb
- Rear turn signal lamp socket
- LED lamp harness connector
- Rear combination lamp harness connector
- Back-up lamp bulb socket
- Back-up lamp bulb
Removal and installation
Removal
- Partially remove trunk side finisher. Refer to INT-43, "TRUNK SIDE FINISHER : Removal and Installation".
- Remove the rear combination lamp nuts (B).
- Disconnect the harness connector (A) from the rear combination lamp.
- Pull the rear combination lamp rearward and remove.
Installation
Installation is the reverse order of removal.
Bulb replacement
WARNING:
Do not touch bulb while it is lit or right after being turned off. Burning may result.
CAUTION:
- Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
- Do not leave the bulb out of the lamp reflector for a long time
because dust, moisture, smoke, etc.
may affect the performance of the lamp.
REAR TURN SIGNAL LAMP BULB
Removal
- Remove the rear combination lamp. Refer to EXL-126, "Removal and Installation".
- Rotate the rear turn signal lamp bulb socket counterclockwise and remove.
- Remove the rear turn signal lamp bulb from bulb socket.
Installation
Installation is in the reverse order of removal.
CAUTION:
After installing, be sure to install the bulb socket securely to ensure watertightness
STOP/TAIL LAMP
The stop/tail lamp is integrated into the rear combination lamp and is serviced as an assembly. Refer to EXL- 126, "Removal and Installation".
BACK-UP LAMP BULB
Removal
- Remove the rear combination lamp. Refer to EXL-126, "Removal and Installation".
- Rotate the back-up lamp bulb socket counterclockwise and remove.
- Remove the back-up lamp bulb from bulb socket.
Installation
Installation is in the reverse order of removal.
CAUTION:
After installing, be sure to install the bulb socket securely to ensure watertightness.
License plate lamp
Removal and Installation
REMOVAL
Remove the license lamp finisher. Refer to EXT-44, "Removal and
Installation".
Disconnect the harness connector (A) from the license plate
lamp ( ...
Combination switch
Exploded view
Combination switch
Combination switch harness connector
Front
NOTE:
Shown with the steering wheel removed for clarity only.
Removal and installation
REMOVAL
CAUTION:
...
Other materials:
Symptom diagnosis
Audio system
Symptom table
Related to audio
Related to hands-free phone
Before performing diagnosis, confirm that the cellular phone being used
by the customer is compatible with
the vehicle.
It is possible that a malfunction is occurring due to a version change
of the p ...
P0452 EVAP Control system pressure sensor
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0452
EVAP SYS PRES SEN
(Evaporative emission system
pressure sensor/switch low)
An excessively low voltage from the
sensor is se ...
Parking brake control
Exploded View
Parking brake lever assembly
Adjusting nut
Parking brake switch
Front parking brake cable
Rear parking brake cable (LH)
Rear parking brake cable (RH)
Front
Removal and Installation
REMOVAL
Parking Brake Control
Remove rear wheels and t ...
