Nissan Sentra Service Manual: Rear bumper
Exploded view
- Rear bumper side bracket (LH)
- Rear bumper reinforcement
- Rear bumper energy absorber
- Rear bumper fascia reflector (LH)
- Rear bumper fascia reflector (RH)
- Rear bumper fascia
- Rear bumper side bracket (RH)
Pawl
Removal and installation
CAUTION:
Bumper fascia is made of resin. Use care when handling to prevent damage. Avoid contact with oily substances.
REMOVAL
- Remove rear combination lamps (LH/RH). Refer to EXL-126, "Removal and Installation".
- Remove the clips (A) (LH/RH) and bolts (B) (LH/RH) from the rear bumper fascia upper side.
- Apply protective tape (A) to protect the components from damage on each side as shown.
- Remove clips (A) (LH/RH) from rear bumper fascia lower side.
- Remove bolts (A) (LH/RH) from rear bumper fascia lower side.
- Remove rear bumper fascia screws (A) (LH/RH).
- Release the rear bumper fascia from the rear bumper fascia side bracket on each side (LH/RH) as shown.
: Pawl
CAUTION:
When removing rear bumper fascia, two people are required as to avoid damaging.
- Remove rear bumper fascia.
- Remove the rear bumper fascia reflectors (LH/RH) from rear bumper fascia.
- Remove rear bumper energy absorber.
- Remove rear bumper side bracket screws and the rear bumper side brackets (LH/RH).
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
- The following table shows the specified values for checking normal installation status.
- Fitting adjustment cannot be performed.
Front bumper
Exploded view
Grommet
Front bumper side bracket (RH)
Front under cover
Front air spoiler
Front bumper reinforcement
Front energy absorber
Front fog lamp (RH) (if equipped)
Front ...
Front grille
Exploded view
Core support cover
Front grille
Emblem
Pawl
Removal and installation
REMOVAL
Remove core support cover bolts (A), clips (B) and core support
cover (1).
...
Other materials:
P2858 Clutch B Pressure
DTC Logic
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P2858
CLUTCH B PRESSURE
(Clutch B Pressure Engagement
Performance)
The auxiliary gearbox gear ratio is 2.232 or
more for the auxiliary gearbox 2GR ratio ...
P062F Eeprom
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P062F
EEPROM
(Internal Control Module EEPROM
Error)
Flash ROM error is detected when turning ON
the ignition switch.
TC ...
Precaution for Work
When removing or disassembling each component, be careful not to damage
or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
When removing (disengaging) components with a screwdriver or similar
tool, be sure to wrap the component
with a ...
