Description
Provides the power supply and the ground to control the push-button ignition switch illumination.
Component function check
1.Check push-button ignition switch illumination operation
Consult active test
On : push-button ignition switch illumination on
Off : push-button ignition switch illumination off
Does the push-button ignition switch illumination turn on/off? Yes >> push-button ignition switch illumination circuit is normal.
No >> refer to inl-49, "diagnosis procedure".
Diagnosis procedure
Regarding wiring diagram information, refer to inl-26, "wiring diagram".
1.Check push-button ignition switch illumination power supply output
Is the inspection result normal? Yes >> go to 4.
No >> go to 2.
2.Check push-button ignition switch illumination power supply open circuit
Is the inspection result normal? Yes >> go to 3.
No >> repair or replace harness or connector.
3.Check push-button ignition switch illumination power supply short circuit
Check continuity between bcm harness connector and ground.
Is the inspection result normal? YES >> Replace BCM. Refer to BCS-73, "Removal and Installation" (with Intelligent Key), BCS-126, "Removal and Installation" (without Intelligent Key).
NO >> Repair or replace harness or connector.
4.Check push-button ignition switch illumination ground circuit
Check continuity between push-button ignition switch harness connector and ground.
Is the inspection result normal? Yes >> replace push-button ignition switch. Refer to sec-136, "removal and installation".
No >> repair or replace harness or connector.
Connecting Procedure
NOTE:
The connecting procedure must be performed
when the vehicle is stationary. If the
vehicle starts moving during the procedure,
the procedure will be cancelled.
Press the [ ] button on the
control
panel.
Touch the “Settings” key.
Touch the “Phone & Bluetooth” ke ...
Service
Never use electrical test equipment to check SRS circuits unless
instructed to in this Service Manual.
Before servicing the SRS, turn power switch OFF, disconnect battery
negative terminal and wait 3 minutes
or more.
For approximately 3 minutes after the cables are removed, it is stil ...
Battery
Exploded view
Battery frame
Battery rods
Battery cover
Battery bracket
Battery tray
Battery
Front
Removal and installation (battery)
Removal
Loosen the battery terminal nuts and disconnect both battery negative
and positive terminals.
Caution:
To prevent damage to t ...