Nissan Sentra Owners Manual: Precautions on cruise control

Nissan Sentra Owners Manual / Starting and driving / Cruise control (if so equipped) / Precautions on cruise control

ACCEL/RES switch
COAST/SET switch
CANCEL switch
ON·OFF switch

If the cruise control system malfunctions, it cancels automatically. The CRUISE indicator light in the instrument panel then blinks to warn the driver, see “Warnings/Indicator Lights and Audible Reminders” in the “Instruments and controls” section.
If the CRUISE indicator light blinks, push the cruise control ON·OFF switch off and have the system checked by a NISSAN dealer.
The CRUISE indicator light may blink when the cruise control ON·OFF switch is pushed ON while pushing the ACCEL/RES, COAST/SET, or CANCEL switch. To properly set the cruise control system, use the following procedures.

WARNING

Do not use the cruise control when driving under the following conditions:

When it is not possible to keep the vehicle at a set speed.
In heavy traffic or in traffic that varies in speed.
On winding or hilly roads.
On slippery roads (rain, snow, ice, etc.).
In very windy areas.

Doing so could cause a loss of vehicle control and result in an accident.

Cruise control (if so equipped)

...

Cruise control operations

The cruise control allows driving at a speed between 25 - 89 MPH (40 - 144 km/h) without keeping your foot on the accelerator pedal. To turn on the cruise control, push the ON·OFF switch. The C ...

Other materials:

NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer system will not allow the engine to start without the use of the registered key. If the engine fails to start using a registered key (for example, when interference is caused by another registered key, an automated toll road device or automatic payment device o ...

Front wheel hub and knuckle
Inspection COMPONENT PART Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal. WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE) Check the following items, and replace the part if necessary. Move the wheel hub and bearin ...

P0999 Shift solenoid F
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P0999 SHIFT SOLENOID F (Shift Solenoid F Control Circuit High) The TCM low brake solenoid valve current monitor reading is 200 mA or ...