Nissan Sentra Service Manual: Precaution for supplemental restraint system (srs) "air bag" and "seat belt pre-tensioner"

Nissan Sentra Service Manual / Driver controls / Wiper & washer / Precaution / Precaution for supplemental restraint system (srs) "air bag" and "seat belt pre-tensioner"

The Supplemental Restraint System such as вЂњAIR BAGвЂќ and вЂњSEAT BELT PRE-TENSIONERвЂќ, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is included in the SR and SB section of this Service Manual.

WARNING:

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer.
Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see the SR section.
Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Ignition ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.
When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the battery and wait at least three minutes before performing any service.

Precaution for procedure without cowl top cove.R.

When performing the procedure after removing cowl top cover, cover the lower end of windshield with urethane, etc.

Precaution for work

Precaution

...

Precaution for work

When removing or disassembling each component, be careful not to damage or deform it. If a component may be subject to interference, be sure to protect it with a shop cloth. When removing (d ...

Other materials:

Front passenger side power window does not operate
When both power window main switch and front power window switch are operated WHEN BOTH POWER WINDOW MAIN SWITCH AND FRONT POWER WINDOW SWITCH ARE OPERATED : Diagnosis Procedure 1.CHECK FRONT POWER WINDOW SWITCH (PASSENGER SIDE) Check front power window switch (passenger side). Refer to PW ...

Front bumper
Exploded view Grommet Front bumper side bracket (RH) Front under cover Front air spoiler Front bumper reinforcement Front energy absorber Front fog lamp (RH) (if equipped) Front bumper lower grille Front bumper fascia finisher (RH) (if equipped) Front fog lamp finisher (R ...

Door outside molding
Exploded view Front door assembly Grommet Front door outside molding Rear door outside molding Rear door assembly Door glass Clip Front door outside molding FRONT DOOR OUTSIDE MOLDING : Removal and Installation REMOVAL Remove front door mirror. Refer to MIR-18, &quo ...