Nissan Sentra manuals

Nissan Sentra Service Manual: Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is included in the SR and SB section of this Service Manual.

WARNING:

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

Precaution for Procedure without Cowl Top Cover

When performing the procedure after removing cowl top cover, cover the lower end of windshield with urethane, etc to prevent damage to windshield.

Liquid Gasket


Liquid Gasket

REMOVAL OF LIQUID GASKET SEALING

Tool Number (A): KV10111100 (J-37228)

CAUTION:

Be careful not to damage the mating surfaces.

CAUTION:

Do not damage the mating surfaces.

LIQUID GASKET APPLICATION PROCEDURE


LIQUID GASKET APPLICATION PROCEDURE

  1. Using suitable tool (A), remove old liquid gasket adhering to the liquid gasket application surface and the mating surface.
  1. Wipe the liquid gasket application surface and the mating surface with white gasoline (lighting and heating use) to remove adhering moisture, grease and foreign materials.


  1. Attach liquid gasket tube using suitable tool.

    Use Genuine Liquid Gasket or equivalent.

  2. Apply liquid gasket without gaps to the specified location according to the specified dimensions.


(A) : Groove

: Inside



CAUTION:

If there are specific instructions in this manual, observe them.

Precaution for TCM and Transaxle Assembly Replacement

CAUTION:

Precaution for G Sensor Removal/Installation or Replacement

CAUTION:

To remove/install or replace G sensor, refer to TM-147, "Description".

General Precautions





On Board Diagnosis (OBD) System of CVT and Engine

The ECM has an on board diagnostic system. It will light up the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration.

CAUTION:

Removal and Installation Procedure for CVT Unit Connector

REMOVAL

INSTALLATION


INSTALLATION

  1. Align marking (A) on CVT unit harness connector terminal with marking (B) on bayonet ring. Insert CVT unit harness connector.
  2. Rotate bayonet ring clockwise.


  1. Rotate bayonet ring clockwise until marking (A) on CVT unit harness connector terminal body is aligned with the slit (B) on bayonet ring as shown in the figure (correctly fitting condition).


General Precautions


General Precautions

CVT: RE0F11A
...

Preparation
Special Service Tools The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here. *: The O-ring as a unit part is set as a SST. Commercial Service ...

Other materials:

Front wheel hub and knuckle
Inspection COMPONENT PART Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal. WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE) Check the following items, and replace the part if necessary. Move the wheel hub and bearin ...

If your vehicle overheats
If your vehicle is overheating (indicated by an extremely high temperature gauge reading), or if you feel a lack of engine power, detect abnormal noise, etc., take the following steps. WARNING Do not continue to drive if your vehicle overheats. Doing so could cause engine dama ...

Text messaging
WARNING Laws in some jurisdictions may restrict the use of some of the applications and features, such as social networking and texting. Laws in some jurisdictions may restrict the use of “Text-to-Speech”. Check local regulations before using this feature. ...

© 2014-2024 Copyright www.nisentra.com