Nissan Sentra Service Manual: Periodic maintenance

Nissan Sentra Service Manual / Transmission & driveline / Transaxle & transmission / 6MT: RS6F94R / Periodic maintenance

M/T OIL

Inspection

OIL LEAKAGE

Make sure that gear oil is not leaking from transaxle or around it.

OIL LEVEL

Remove filler plug (1) and gasket from transaxle case.
Check the oil level from filler plug mounting hole as shown.

CAUTION:

Do not start engine while checking oil level.

Set a gasket on filler plug and then install it to transaxle case.

CAUTION:

Do not reuse gasket.

Tighten filler plug to the specified torque. Refer to TM-30 "Exploded View".

CAUTION:

CAUTION:

Do not overtighten the filler plug as this could cause the transaxle case to crack.

Draining

Start engine and let it run to warm up transaxle
Stop engine. Remove drain plug (1) and gasket, using a suitable tool and then drain gear oil.
Set a gasket on drain plug and install it to clutch housing, using a suitable tool.

CAUTION:

Do not reuse gasket.

Tighten drain plug to the specified torque. Refer to TM-30, "Exploded View".

CAUTION:

Do not overtighten the filler plug as this could cause the transaxle case to crack.

Refilling

Refilling

Remove filler plug (1) and gasket from transaxle case.
Fill with new gear oil until oil level reaches the specified limit at filler plug mounting hole as shown.

Oil grade and viscosity : Refer to MA-11, "Fluids and Lubricants".

Oil capacity : Refer to MA-11, "Fluids and Lubricants".

After refilling gear oil, check the oil level. Refer to TM-19, "Inspection".
Set a gasket on filler plug and then install it to transaxle case.

CAUTION:

Do not reuse gasket.

Tighten filler plug to the specified torque. Refer to TM-30, "Exploded View".

CAUTION:

Do not overtighten the filler plug as this could cause the transaxle case to crack.

Symptom diagnosis

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary ...

Removal and installation

SIDE OIL SEAL Removal and Installation REMOVAL Remove front drive shafts. Refer to FAX-18, "6M/T : Removal and Installation (LH)". Remove differential side oil seals (1) from clu ...

Other materials:

Normal operating condition
Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 2,500 rpm under no load (for example, the selector lever position is neutral and engine speed is over 2,500 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies b ...

P1651 Starter motor relay
Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. ECM transmits a control signal to IPDM E/R by CAN communication. Under normal conditions, ECM controls and maintains the starter relay in OFF state during following condition: Engi ...

System description
Component parts POWER DOOR LOCK SYSTEM POWER DOOR LOCK SYSTEM : Component Parts Location BCM (view with instrument panel removed) Front door switch LH Front door lock actuator LH Front door lock assembly LH Front door switch RH Front door lock actuator RH Rear door switch RH ...