Nissan Sentra manuals

Nissan Sentra Service Manual: Periodic maintenance

Normal operating condition
Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 2,500 rpm under no load (for example, the selector lever position is neutral and engine speed is over ...

Idle speed
Inspection 1.CHECK IDLE SPEED With CONSULT Check idle speed in “DATA MONITOR” mode of “ENGINE” using CONSULT. Specification : EC-486, "Idle Speed" With GST Check ...

Other materials:

Reporting safety defects
For USA If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying NISSAN. If NHTSA receives similar complaints, it may open an inv ...

The oil pressure warning lamp does not turn on
Description The oil pressure warning lamp stays off when the ignition switch is turned on. Diagnosis procedure 1.Check combination meter oil pressure warning light Select METER/M&A on CONSULT. Observe oil w/l data monitor while operating the ignition switch. Is the inspection r ...

B0094 Crash zone sensor
Description DTC B0094 CRASH ZONE SENSOR The crash zone sensor is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the crash zone sensor. PART LOCATION Refer to SRC-5, "Component Parts Location". DTC ...

© 2014-2026 Copyright www.nisentra.com