Nissan Sentra Owners Manual: Parking/parking on hills

Nissan Sentra Owners Manual / Starting and driving / Parking/parking on hills

WARNING

Do not stop or park the vehicle over flammable materials such as dry grass, waste paper or rags. They may ignite and cause a fire.
Safe parking procedures require that both the parking brake be set and the transmission placed into P (Park) for CVT models or in an appropriate gear for manual transmission models. Failure to do so could cause the vehicle to move unexpectedly or roll away and result in an accident. Make sure the shift lever has been pushed as far forward as it can go and cannot be moved without depressing the foot brake pedal.
Never leave the engine running while the vehicle is unattended.
Do not leave children unattended inside the vehicle. They could unknowingly activate switches or controls. Unattended children could become involved in serious accidents.

Firmly apply the parking brake.
Manual transmission models:

Place the shift lever in the R (Reverse) position.

When parking on an uphill grade, place the shift lever in 1st gear.

Continuously Variable Transmission (CVT) models: Move the shift lever into the P (Park) position.

To help prevent the vehicle from rolling into traffic when parked on an incline, it is a good practice to turn the wheels as illustrated.

HEADED DOWNHILL WITH CURB: 1 Turn the wheels into the curb and move the vehicle forward until the curb side wheel gently touches the curb.
HEADED UPHILL WITH CURB: 2 Turn the wheels away from the curb and move the vehicle back until the curb side wheel gently touches the curb.
HEADED UPHILL OR DOWNHILL, NO CURB: 3 Turn the wheels toward the side of the road so the vehicle will move away from the center of the road if it moves.

Place the ignition switch in the LOCK position and remove the key.

Increasing fuel economy

Keep your engine tuned up. Follow the recommended scheduled maintenance. Keep the tires inflated to the correct pressure. Low tire pressure increases tire wear and lowers fuel economy. ...

Power steering

WARNING If the engine is not running or is turned off while driving, the power assist for the steering will not work. Steering will be harder to operate. When the power stee ...

Other materials:

P2100, P2103 Throttle control motorrelay
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P2100 ETC MOT PWR-B1 (Throttle actuator вЂњAвЂќ control motor circuit/ open) ECM detects a voltage of power source for t ...

Adjustment of steering angle sensor neutral position
Description Refer to the table below to determine if adjustment of steering angle sensor neutral position is required. ×: Required вЂ“: Not required Work Procedure ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION CAUTION: To adjust neutral position of steering angle sensor, ...

Both side headlamps do not switch to high beam
Description The headlamps (both sides) do not switch to high beam when the lighting switch is in the hi or pass setting. Diagnosis procedure 1.Combination switch (lighting and turn signal switch) inspection Check the combination switch (lighting and turn signal switch). Refer to bcs-72, &q ...