Nissan Sentra Service Manual: Parking brake shoe
Adjustment - Drum Brake
If equipped with drum brakes, refer to PB-11, "Inspection and Adjustment".
Adjustment - Disc Brake
-
Adjust parking brake lever stroke. Refer to PB-4, "Inspection and Adjustment".
-
Perform parking brake break-in (drag on) operation by driving vehicle under the following conditions:
-
Drive forward
-
Vehicle speed: Approx. 43 km/h (27 MPH) set (constant and forward)
-
Parking brake operating force: 125 N (12.8 kg-f, 28.1 lb-f) set contact
-
Time: Approx. 8 sec.
CAUTION:
To prevent lining from getting too hot, allow a cool off period of approximately 5 minutes after every break-in operation.
-
After the break-in procedure, check parking brake lever stroke.
CAUTION:
If it is out of the specification, adjust again. Refer to PB-4, "Inspection and Adjustment".
Revision:
Parking brake system
Inspection and Adjustment
INSPECTION
Lever Stroke
Operate the parking brake lever with a force of 196 N (20.0
kg-f, 44.1 lb-f). Check that the lever stroke is
within the specified number ...
Other materials:
Ignition coil
Exploded View
Ignition coil
Spark plug
Rocker cover
Removal and Installation
REMOVAL
Remove the engine room cover. Refer to EM-24, "Exploded View".
Disconnect the harness connector from the ignition coil.
Remove the ignition coil.
CAUTION:
Do not drop or shock i ...
Wheel side
WHEEL SIDE : Removal and Installation
REMOVAL
Remove the wheel and tire using power tool. Refer to WT-47, "Exploded
View".
Remove the brake caliper torque member bolts, leaving the brake hose
attached. Position the brake caliper
aside with wire. Refer to BR-41, "BRAKE C ...
Strg branch line circuit
Diagnosis Procedure
1.Check connector
Turn the ignition switch off
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the steering angle sensor for
damage, bend and loose connection
(unit side and connector side).
Is the inspection result ...
