DTC Logic
DTC DETECTION LOGIC
NOTE:
DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detecting condition | Possible cause |
P2101 | ETC FNCTN/CIRC-B1 (Throttle actuator “A” control motor circuit range/performance) | Electric throttle control function does not operate properly. |
|
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 11 V when engine is running.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
Is DTC detected? YES >> Proceed to EC-425, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK THROTTLE CONTROL MOTOR RELAY INPUT SIGNAL
Check the voltage between ECM harness connector terminals as per the following conditions.
Is the inspection result normal? YES >> GO TO 4.
NO >> GO TO 2.
2.CHECK THROTTLE CONTROL MOTOR RELAY INPUT SIGNAL CIRCUIT
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace error-detected parts.
3.CHECK THROTTLE CONTROL MOTOR RELAY POWER SUPPLY CIRCUIT
Is the inspection result normal? YES >> Perform the trouble diagnosis for power supply circuit.
NO >> Repair or replace error-detected parts.
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace error-detected parts.
5.CHECK ELECTRIC THROTTLE CONTROL ACTUATOR VISUALLY
Is the inspection result normal? YES >> GO TO 6.
NO >> Remove the foreign matter and clean the electric throttle control actuator inside, then perform throttle valve closed position learning. Refer to EC-139, "Work Procedure".
6.CHECK THROTTLE CONTROL MOTOR
Check the throttle control motor. Refer to EC-429, "Component Inspection (Throttle Control Motor)".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-39, "Intermittent Incident".
NO >> Replace electric throttle control actuator. Refer to EM-27, "Removal and Installation".
Component Inspection (Throttle Control Motor)
1.CHECK THROTTLE CONTROL MOTOR
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace electric throttle control actuator. Refer to EM-27, "Removal and Installation".
Wiring diagram
Sport mode system
Wiring diagram
...
EPS branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the EPS control unit for damage,
bend and loose connection (unit
side and connector side).
Is the inspection result norm ...
Precaution for Brake Control System
Always perform a pre-driving check to drive the vehicle.
Always check speed and safety while driving the vehicle.
To operate CONSULT while driving, more than one person is
required to be in the vehicle to avoid interference
to driving and ensure safety.
Slight vibrations ar ...