Description
ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. ECM transmits a control signal to IPDM E/R via BCM by CAN communication.
Under normal conditions, ECM controls and maintains the starter relay in OFF state during following condition:
When detecting a decrease in engine speed due to rapid deceleration or heavy load condition, ECM controls and reactivates the starter relay.
IPDM E/R detects a control state of starter relay and starter control relay and transmits a feedback signal to ECM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
Refer to SEC-112, "DTC Logic" or SEC-114, "DTC Logic".
DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detecting condition | Possible cause |
P1652 | STR MTR SYS COMM (Starter motor system communication) | ECM detects malfunction in starter motor drive circuit of the IPDM E/R. | IPDM E/R |
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION
Is DTC detected? YES >> Proceed to EC-404, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK SELF-DIAGNOSTIC RESULT IN BCM
With CONSULT
Check self-diagnostic result in BCM.
Are any DTC detected? YES >> Check the DTC. Refer to BCS-49, "DTC Index" (with intelligent key), BCS-109, "DTC Index" (without intelligent key).
NO >> GO TO 2.
2.CHECK SELF-DIAGNOSTIC RESULT IN IPDM E/R
With CONSULT
Check self-diagnostic result in IPDM E/R.
Are any DTC detected? YES >> Check the DTC. Refer to PCS-20, "DTC Index" (with intelligent key), PCS-48, "DTC Index" (without intelligent key).
NO >> GO TO 3.
3.PERFORM DTC CONFIRMATION PROCEDURE
Is the P1652 displayed again? YES >> GO TO 4.
NO >> INSPECTION END
4.CHECK INTERMITTENT INCIDENT
Check intermittent incident. Refer to GI-39, "Intermittent Incident".
Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-58, "Removal and Installation".
NG >> Repair or replace error-detected parts.
Front bumper
Exploded view
Grommet
Front bumper side bracket (RH)
Front under cover
Front air spoiler
Front bumper reinforcement
Front energy absorber
Front fog lamp (RH) (if equipped)
Front bumper lower grille
Front bumper fascia finisher (RH)
(if equipped)
Front fog lamp finisher (R ...
System description
COMPONENT PARTS
Component Part Location
ECM
IPDM E/R
BCM (view with combination meter
removed)
A/C auto amp. (view with A/C switch
assembly removed)
A/C switch assembly
A/C Compressor
Refrigerant pressure sensor (view
with front bumper fascia removed)
Fuse Block (J/ ...
Wiring diagram
Manual air conditioning system
Wiring Diagram
Manual heater system
Wiring Diagram
...