Nissan Sentra manuals

Nissan Sentra Service Manual: P1574 ASCD Vehicle speed sensor

Description

The ECM receives two vehicle speed sensor signals via CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to EC-51, "AUTOMATIC SPEED CONTROL DEVICE (ASCD) : System Description" for ASCD functions.

DTC Logic

DTC DETECTION LOGIC

NOTE:

DTC No.

CONSULT screen terms (Trouble diagnosis content)

DTC detecting condition

Possible cause

P1574 ASCD VHL SPD SEN (ASCD VHL SPD SEN) ECM detects a difference between two vehicle speed signals is out of the specified range.
  • Harness or connectors (CAN communication line is open or shorted.)
  • ABS actuator and electric unit (control unit)
  • TCM
  • ECM

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine.
  2. Drive the vehicle at more than 40 km/h (25 MPH).

CAUTION:

Always drive vehicle at a safe speed.

NOTE:

This procedure may be conducted with the drive wheels lifted in the shop or by driving the vehicle.

If a road test is expected to be easier, it is unnecessary to lift the vehicle.

  1. Check DTC.

Is DTC detected? YES >> Proceed to EC-397, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK DTC WITH TCM

Check DTC with TCM. Refer to TM-108, "CONSULT Function".

Is DTC detected?

NO >> GO TO 2.

YES >> Perform trouble shooting relevant to DTC indicated.

2.CHECK DTC WITH “ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)”

Check DTC with ABS actuator and electric unit (control unit). Refer to BRC-31, "CONSULT Function (ABS)".

Is DTC detected? NO >> INSPECTION END

YES >> Perform trouble shooting relevant to DTC indicated.

P1572 ASCD Brake switch
DTC Logic DTC DETECTION LOGIC NOTE: If DTC P1572 is displayed with DTC P0605, first perform the trouble diagnosis for DTC P0605. Refer to EC-348, "DTC Logic". This self-diagnosi ...

P1650 Starter motor relay 2
Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. ECM transmits a control signal to IPDM E/R via BCM by CAN communication. Under normal ...

Other materials:

Steering wheel
Exploded View Driver air bag module Steering wheel Steering column assembly Removal and Installation REMOVAL NOTE: When reconnecting spiral cable, fix cable with a tape so that fixing case and rotating part keep aligned. This will omit neutral position alignment procedu ...

Precautions for drive shaft
Observe the following precautions when disassembling and assembling drive shaft. Do not disassemble joint sub-assembly because it is non-overhaul parts. Perform work in a location which is as dust-free as possible. Clean the parts, before disassembling and assembling. Prevent the entry o ...

Front wiper auto stop signal circuit
Component function check 1. Check front wiper (auto stop) operation Consult data monitor Select “WIP AUTO STOP” of IPDM E/R DATA MONITOR item. Operate the front wiper. With the front wiper operation, check the monitor status. Is the inspection result normal? YES >> ...

© 2014-2024 Copyright www.nisentra.com