Nissan Sentra Service Manual: P0965 Pressure control solenoid B

Nissan Sentra Service Manual / Transmission & driveline / Transaxle & transmission / CVT: RE0F11A / P0965 Pressure control solenoid B

DTC Logic

DTC DETECTION LOGIC

DTC

CONSULT screen terms (Trouble diagnosis content)

DTC detection condition

Possible causes

P0965

PC SOLENOID B (Pressure control solenoid B control circuit range performance)

The detection conditions continuously for 5 seconds or more under the following diagnosis conditions:

Diagnosis conditions

Selector lever: Other than вЂњPвЂќ and вЂњNвЂќ positions
Auxiliary gearbox shifting is not in progress.
Engine speed: More than 500 rpm

Detection condition A

Actual primary pulley ratio: 2.0 вЂ“ 2.4
Target primary pulley ratio: Less than 1.2

Detection condition B

Actual primary pulley ratio: 0.35 вЂ“ 0.75
Target primary pulley ratio: More than 1.55

Primary pressure solenoid valve

DTC CONFIRMATION PROCEDURE

CAUTION:

Be sure to perform вЂњTM-205, "Diagnosis Procedure"вЂќ and then perform вЂњDTC CONFIRMATION PROCEDUREвЂќ.
Never perform вЂњDTC CONFIRMATION PROCEDUREвЂќ before the repairs. Doing so may result in a secondary malfunction.
Be careful of the driving speed.

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

Start the engine
Drive the vehicle.
Maintain the following conditions for 20 seconds or more.

Vehicle speed : 20 km/h (13 MPH) or more

Stop the vehicle
Check the first trip DTC.

Is вЂњP0965вЂќdetected? YES >> Go to TM-205, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK INTERMITTENT INCIDENT

Refer to GI-39, "Intermittent Incident".

Is the inspection result normal? YES >> Replace transaxle assembly. Refer to TM-283, "Removal and Installation".

NO >> Repair or replace malfunctioning parts.

P0963 Pressure control solenoid A

DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P0963 PC SOLENOID A (Pressure Control So ...

P0966 Pressure control solenoid B

DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P0966 PC SOLENOID B (Pressure Control So ...

Other materials:

Does not stop fully-open or fullyclosed position
Diagnosis procedure 1. Perform initialization procedure Perform initialization procedure. Refer to RF-18, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement". Is the inspection result normal? YES >> Inspection End. NO >> Perform basic ins ...

Body alignment
Body Center Marks A mark has been placed on each part of the body to indicate the vehicle center. When repairing parts damaged by an accident which might affect the vehicle frame (members, pillars, etc.), more accurate and effective repair will be possible by using these marks together with ...

Increasing fuel economy
Keep your engine tuned up. Follow the recommended scheduled maintenance. Keep the tires inflated to the correct pressure. Low tire pressure increases tire wear and lowers fuel economy. Keep the wheels in correct alignment. Improper alignment increases tire wear and lowers fuel eco ...