Nissan Sentra manuals

Nissan Sentra Service Manual: P062F Eeprom

DTC Logic

DTC DETECTION LOGIC

DTC

CONSULT screen terms (Trouble diagnosis content)

DTC detection condition

Possible causes

P062F EEPROM (Internal Control Module EEPROM Error) Flash ROM error is detected when turning ON the ignition switch.
  • TCM (flash ROM)
  • Harness or connector [TCM power supply (back-up) circuit is open or shorted]

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another “DTC CONFIRMATION PROCEDURE” occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

  1. Start the engine.
  2. Check the DTC.

Is “P062F” detected? YES >> Go to TM-160, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK INTERMITTENT INCIDNT

Refer to GI-39, "Intermittent Incident".

Is the inspection result normal? YES >> Replace the TCM. Refer to TM-263, "Removal and Installation".

NO >> Repair or replace malfunctioning parts.

U1117 Lost communication (ABS)
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms [Trouble diagnosis content] DTC detection condition Possible causes U1117 LOST COMM (ABS) [Lost Communication ...

P0705 Transmission range sensor A
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms [Trouble diagnosis content] DTC detection condition Possible causes P0705 T/M RANGE SENSOR A [Transmission R ...

Other materials:

Maintenance precautions
When performing any inspection or maintenance work on your vehicle, always take care to prevent serious accidental injury to yourself or damage to the vehicle. The following are general precautions which should be closely observed. WARNING Park the vehicle on a level surface, apply ...

Precaution for supplemental restraint system (SRS) "air bag" and "seat belt pre-tensioner"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system ...

Diagnosis and repair workflow
Work Flow OVERALL SEQUENCE DETAILED FLOW 1. OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. 2. CONFIRM THE SYMPTOM Check the malfunction on the ...

© 2014-2025 Copyright www.nisentra.com