Nissan Sentra manuals

Nissan Sentra Service Manual: P060A ECM

DTC Logic

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms (Trouble diagnosis content)

DTC detecting condition

Possible cause

P060A CONTROL MODULE (Internal control module monitoring processor performance) ECM internal monitoring processor is malfunctioning. ECM

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine and wait at least 10 seconds
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Repeat step 1 and 2 for 5 times.
  4. Turn ignition switch ON.
  5. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Proceed to EC-351, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON.
  2. Erase DTC.
  3. Perform DTC confirmation procedure. Refer to EC-351, "DTC Logic".

Is the 1st trip DTC P060A displayed again? YES >> Replace ECM. Refer to EC-485, "Removal and Installation".

NO >> INSPECTION END

P0607 ECM
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0607 ECM (Control module performance) ...

P060B ECM
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P060B CONTROL MODULE (Internal control ...

Other materials:

Rear shock absorber
Exploded View Rear suspension beam Shock absorber Bound bumper Bound bumper cover Washer Bushing Distance tube Bushing Washer Piston rod lock nut Cap Front Removal and Installation REMOVAL Remove the rear shock tower access flap. Remove the cap from the rear s ...

On board refueling vapor recovery(ORVR)
Component Function Check 1.CHECK ORVR FUNCTION Check whether the following symptoms are present. Fuel odor from EVAP canister is strong Cannot refuel/Fuel odor from the fuel filler opening is strong while refueling. Are any symptoms present? YES >> Proceed to EC-468, "Diagn ...

P1586 G Sensor
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P1586 G Sensor (Gravity Sensor Circuit) When the following diagnosis conditions are satisfied and the detection conditions are satisfi ...

В© 2014-2024 Copyright www.nisentra.com