Nissan Sentra manuals

Nissan Sentra Service Manual: P0606 ECM

Nissan Sentra Service Manual / Engine / Engine control system / Dtc/circuit diagnosis / P0606 ECM

DTC Logic

DTC DETECTION LOGIC

DTC No.

 CONSULT screen terms (Trouble diagnosis content)

 DTC detecting condition

 Possible cause
P0606 CONTROL MODULE (Control module processor) Malfunction in ECM processor. ECM

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE-1

  1. Turn ignition switch ON (engine stopped) and wait at least 10 seconds.

CAUTION:

Never start engine during this procedure.

  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Proceed to EC-349, "Diagnosis Procedure".

NO >> GO TO 3.

3.PERFORM DTC CONFIRMATION PROCEDURE-2

  1. Start engine.
  2. Rev up the engine quickly to approximately 3,000 rpm under unloaded condition and completely release the accelerator pedal.
  3. Let the engine idle and wait at least 10 seconds.
  4. Turn ignition switch OFF and wait at least 10 seconds.
  5. Turn ignition switch ON.
  6. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Proceed to EC-349, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON.
  2. Erase DTC.
  3. Perform DTC confirmation procedure for 3 times. Refer to EC-349, "DTC Logic".

Is the 1st trip DTC P0606 displayed again? YES >> Replace ECM. Refer to EC-485, "Removal and Installation".

NO >> INSPECTION END

P0605 ECM
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0605 ECM [Internal control module ...

P0607 ECM
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0607 ECM (Control module performance) ...

Other materials:

Wiring diagram
Display audio without bose Wiring diagram ...

Rear drum brake
Brake Burnishing CAUTION: Burnish contact surfaces between brake drum and brake lining according to the following procedure after refinishing or replacing brake drum, or if a soft pedal occurs at very low mileage. Be careful of vehicle speed because the brake does not operate firml ...

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system ...

© 2014-2025 Copyright www.nisentra.com