Nissan Sentra manuals

Nissan Sentra Service Manual: P0605 ECM

Nissan Sentra Service Manual / Engine / Engine control system / Dtc/circuit diagnosis / P0605 ECM

DTC Logic

DTC DETECTION LOGIC

DTC No.

 CONSULT screen terms (Trouble diagnosis content)

 DTC detecting condition

 Possible cause
P0605 ECM [Internal control module read only memory (ROM) error] Malfunction in the internal ROM of ECM. ECM

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON (engine stopped) and wait least 20 minutes.

CAUTION:

Never start engine during this procedure.

  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Proceed to EC-348, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON.
  2. Erase DTC.
  3. Perform DTC confirmation procedure. Refer to EC-348, "DTC Logic".

Is the 1st trip DTC P0605 displayed again? YES >> Replace ECM. Refer to EC-485, "Removal and Installation".

NO >> INSPECTION END

P0604 ECM
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0604 ECM [Internal control module ...

P0606 ECM
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0606 CONTROL MODULE (Control module p ...

Other materials:

Clutch pedal
Inspection and Adjustment INSPECTION The Height of Clutch Pedal Pull back the floor trim and remove front floor spacer (LH) for access to floor panel. Check that the clutch pedal height (H1) from the floor panel (1) is within the reference value. Clutch pedal height (H1) Replace ...

P060A ECM
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P060A CONTROL MODULE (Internal control module monitoring processor performance) ECM internal monitoring processor is malfunctioning. ...

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injur ...

© 2014-2025 Copyright www.nisentra.com