Nissan Sentra Service Manual: P0460 Fuel level sensor

Nissan Sentra Service Manual / Engine / Engine control system / Dtc/circuit diagnosis / P0460 Fuel level sensor

DTC Logic

DTC DETECTION LOGIC

NOTE:

If DTC P0460 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
If DTC P0460 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to EC-350, "DTC Logic".

When the vehicle is parked, naturally the fuel level in the fuel tank is stable. It means that output signal of the fuel level sensor does not change. If ECM senses sloshing signal from the sensor, fuel level sensor malfunction is detected.

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detecting condition	Possible cause
P0460	FUEL LEV SEN SLOSH (Fuel Level Sensor ″A″ Circuit)	Even though the vehicle is parked, a signal being varied is sent from the fuel level sensor to ECM.	Harness or connectors (The CAN communication line is open or shorted) Harness or connectors (The sensor circuit is open or shorted) Combination meter Fuel level sensor

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

Start engine and wait maximum of 2 consecutive minutes.
Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Proceed to EC-326, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK COMBINATION METER FUNCTION

Refer to MWI-17, "CONSULT Function (METER/M&A)".

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-39, "Intermittent Incident".

NO >> Refer to MWI-58, "Diagnosis Procedure".

P0456 EVAP Control system

DTC Logic DTC DETECTION LOGIC This diagnosis detects leaks in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve, using the negative pressure caused by decrease ...

P0461 Fuel level sensor

DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0461 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX. If DTC P0461 is displayed with DTC P0607, first perform the ...

Other materials:

C1607, C1608 EPS Control unit
DTC Logic DTC DETECTION LOGIC Dtc Display item Malfunction detected condition Possible cause C1607 EEPROM When the memory (EEPROM) system malfunction is detected in EPS control unit. Eps control unit C1608 CONTROL UNIT When the internal malfuncti ...

Main line between ipdm-e and dlc circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). Harness connector E4 Harness connec ...

Push-button ignition switch illumination circuit
Description Provides the power supply and the ground to control the push-button ignition switch illumination. Component function check 1.Check push-button ignition switch illumination operation Consult active test Turn the ignition switch ON. Select engine sw illumi of bcm (intelligen ...