Nissan Sentra Service Manual: Optical sensor
Removal and installation
REMOVAL
- Remove the defroster grille (LH) using a suitable tool.
- Disconnect the harness connector from the optical sensor.
- Release the pawls and remove the optical sensor.
INSTALLATION
Installation is in the reverse order of removal.
Hazard switch
Removal and Installation
REMOVAL
Remove cluster lid C (1). Refer to IP-20, "Removal and Installation
- Cluster Lid C".
Release pawls at ( ) and remove hazard switch (2).
INST ...
Other materials:
Vin registration
Description
VIN Registration is an operation to registering VIN in ECM. It must be
performed each time ECM is replaced.
NOTE:
Accurate VIN which is registered in ECM may be required for Inspection &
Maintenance (I/M).
Work Procedure
1.CHECK VIN
Check the VIN of the vehicle and note it. ...
Starting the engine (models with NISSAN Intelligent Key® system)
Apply the parking brake.
Continuously Variable Transmission:
Move the shift lever to P (Park) or N (Neutral).
P (Park) is recommended.
The starter is designed not to operate if
the shift lever is in any of the driving
positions.
Manual Transmission:
Move the shift lever to N ( ...
U1000 Can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real-time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent malfunction
detection ability.
Many electronic control units are equipped onto a vehicle, an ...
