Nissan Sentra Owners Manual: Operating tips
CAUTION
- Do not use alcohol, benzine or thinner
to clean the camera. This will cause
discoloration. To clean the camera,
wipe with a cloth dampened with a diluted
mild cleaning agent and then wipe
with a dry cloth.
- Do not damage the camera as the monitor
screen may be adversely affected.
- When the shift lever is shifted to R (Reverse),
the monitor screen automatically
changes to the RearView Monitor mode.
However, the radio can be heard.
- It may take some time until the RearView
Monitor is displayed after the shift lever has
been shifted to R (Reverse). Objects may be
distorted momentarily until the RearView
Monitor screen is displayed completely.
When the shift lever is returned to a position
other than R (Reverse), it may take some
time until the screen changes. Objects on
the screen may be distorted until they are
completely displayed.
- When the temperature is extremely high or
low, the screen may not clearly display objects.
This is not a malfunction.
- When strong light directly enters the camera,
objects may not be displayed clearly.
- Vertical lines may be seen in objects on the
screen. This is due to strong reflected light
from the bumper. This is not a malfunction.
- The screen may flicker under fluorescent
light. This is not a malfunction.
- The colors of objects on the RearView Monitor
may differ somewhat from those of the
actual object
- When the contrast of objects is low at night,
pressing the SETTING button or [
]
button may not change the brightness.
- Objects on the monitor may not be clear in a
dark place or at night.
- If dirt, rain or snow attaches to the camera,
the RearView Monitor may not display objects.
Clean the camera.
- Do not use body wax on the camera window.
If body wax does get on the camera window,
wipe off the wax with a clean cloth dampened
with mild detergent diluted with water.
Without Navigation System
The procedure for adjusting the quality of the
screen differs depending on the type of screen
present on the vehicle.
For vehicles without Navigation System:
Pr ...
Adjust air flow direction by moving the vent
slides.
Open or close the vents by using the dial. Move
the dial toward the to open the
vents or
toward the to close them.
...
Other materials:
Power generation voltage variable control system operation inspection
Diagnosis Procedure
Regarding wiring diagram information. Refer to chg-9, "wiring diagram".
Caution:
When performing this inspection, always use a charged battery that has
completed the battery inspection.
(When the charging rate of the battery is low, the response speed of the vol ...
1144 Incomplete steering angle sensor adjustment
DTC Logic
Dtc detection logic
Dtc
Display item
Malfunction detected condition
Possible causes
C1144
St ang sen signal
When neutral position adjustment of steering angle
sensor is not complete.
Harness or connector
Steering angle sensor
Abs actu ...
Clutch pedal
Exploded View
Clutch pedal
Stopper rubber
Clip
Clutch interlock switch (if equipped)
Clutch pedal position switch (if equipped)
Pedal pad
Pedal stopper rubber
Removal and Installation
REMOVAL
Remove instrument lower panel LH. Refer to IP-21, "Removal and
Installa ...
В© 2014-2025 Copyright www.nisentra.com