Nissan Sentra manuals

Nissan Sentra Service Manual: Od off indicator lamp

Nissan Sentra Service Manual / Transmission & driveline / Transaxle & transmission / CVT: RE0F11A / Od off indicator lamp

Component Function Check

1.CHECK OD OFF INDICATOR LAMP FUNCTION

Check OD OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON.

Is the inspection result normal? YES >> INSPECTION END

NO >> Go to TM-239, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC (TCM)

With CONSULT


  1. Turn ignition switch ON.
  2. Check “Self Diagnostic Results” in “TRANSMISSION”.

Is any DTC detected? YES >> Check DTC detected item. Refer to TM-126, "DTC Index".

NO >> GO TO 2.

2.CHECK DTC (COMBINATION METER)

Check “Self Diagnostic Results” in “METER/M&A”. With CONSULT


Check “Self Diagnostic Results” in “METER/M&A”.

Is any DTC detected? YES >> Check DTC detected item. Refer to MWI-26, "DTC Index".

NO >> GO TO 3.

3.CHECK COMBINATION METER INPUT SIGNAL

With CONSULT


  1. Shift the selector lever to “D” position.
  2. Select “Data Monitor” in “METER/M&A”.
  3. Select “O/D OFF IND”.
  4. Check that “O/D OFF IND” turns ON/OFF when overdrive control switch is operated. Refer to MWI-20, "Reference Value".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".

NO >> GO TO 4.

4.CHECK TCM INPUT/OUTPUT SIGNAL

With CONSULT


  1. Select “Data Monitor” in “TRANSMISSION”.
  2. Select “SPORT MODE SW”.
  3. Check that “SPORT MODE SW” turns ON/OFF when overdrive control switch is operated. Refer to TM- 114, "Reference Value".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".

NO >> Check overdrive control switch circuit. Refer to TM-236, "Diagnosis Procedure".

Overdrive control switch
Component Function Check 1.CHECK SPORT INDICATOR LAMP FUNCTION Check OD OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON. Is the inspection result normal? YES &g ...

Shift position indicator circuit
Component Parts Function Inspection 1.CHECK SHIFT POSITION INDICATOR Start the engine. Shift selector lever. Check that the selector lever position and the shift position indicator on the ...

Other materials:

Headlamp (hi) circuit
Description The IPDM E/R (intelligent power distribution module engine room) controls the headlamp high relay based on inputs from the BCM over the CAN communication lines. When the headlamp high relay is energized, power flows through fuses 41 and 42, located in the IPDM E/R. Power then flo ...

Changing wheels and tires
Tire rotation NISSAN recommends rotating the tires every 7,500 miles (12,000 km). See “Flat tire” in the “In case of emergency” section of this manual for tire replacing procedures. As soon as possible, tighten the wheel nuts to the specified torque with a torque wrench. Wheel ...

Driver side door mirror defogger
Description Heats the heating wire with the power supply from the rear window defogger relay to prevent the door mirror from fogging up. Component Function Check Check that heating wire of door mirror defogger lh is heated when turning the rear window defogger switch on. Is the inspect ...

© 2014-2024 Copyright www.nisentra.com