Nissan Sentra Service Manual
- General information
- Engine
- Engine mechanical
- Engine lubrication system
- Engine cooling system
- Engine control system
- Fuel system
- Exhaust system
- Starting system
- Accelerator control system
- Transmission & driveline
- Suspension
- Brakes
- Steering
- Restraints
- Ventilation, heater & air conditioner
- Body interior
- Body exterior, doors, roof & vehicle security
- Door & lock
- Security control system
- Glass & window system
- Power window control system
- Roof
- Exterior
- Body repair
- Driver controls
- Electrical & power control
- Power outlet
- Body control system
- Lan system
- Power control system
- Charging system
- Power supply, ground & circuit elements
- Driver information & multimedia
- Cruise control & driver assistance
- Maintenance
Owner’s Manual/Service Manual order information
Genuine NISSAN Service Manuals for this model
year and prior can be purchased. A genuine
NISSAN Service Manual is the best source of
service and repair information for your vehicle.
This manual ...
Other materials:
Performance test
Inspection
INSPECTION PROCEDURE
Connect recovery/recycling/recharging equipment (for HFC-134a) or
manifold gauge.
Start the engine, and set to the following condition.
Test condition
Maintain test condition until A/C system becomes stable. (Approximately
10 minutes)
Check t ...
Low tire pressure warning lamp
Symptom Table
Low tire pressure warning lamp symptom chart
Note:
If tire pressure sensor wake-up operation is not completed for two or more
tire pressure sensors, the applicable
low tire pressure warning lamp blinking patterns are displayed continuously.
(Example: blinks once/off/bl ...
P1652 Starter motor system comm
Description
ECM controls ON/OFF state of the starter relay, according to the engine and
vehicle condition. ECM transmits
a control signal to IPDM E/R via BCM by CAN communication.
Under normal conditions, ECM controls and maintains the starter relay in OFF
state during following condition:
...
