Nissan Sentra manuals

Nissan Sentra Owners Manual: NISSAN Intelligent Key® (if so equipped)

Nissan Sentra Owners Manual / Pre-driving checks and adjustments / Keys / NISSAN Intelligent Key® (if so equipped)

Your vehicle can only be driven with the Intelligent Keys which are registered to your vehicle’s Intelligent Key components and NISSAN Vehicle Immobilizer System components.

Never leave these keys in the vehicle.

As many as 4 Intelligent Keys can be registered and used with one vehicle. The new keys must be registered by a NISSAN dealer prior to use with the Intelligent Key and NISSAN Vehicle Immobilizer System of your vehicle. Since the registration process requires erasing all memory in the Intelligent Key components when registering new keys, be sure to take all Intelligent Keys that you have to the NISSAN dealer.

CAUTION

Listed below are conditions or occurrences which will damage the Intelligent Key:

If an Intelligent Key is lost or stolen, NISSAN recommends erasing the ID code of that Intelligent Key from the vehicle.

This may prevent the unauthorized use of the Intelligent Key to operate the vehicle.

For information regarding the erasing procedure, contact a NISSAN dealer.

Mechanical key

The Intelligent Key contains the mechanical key.


The Intelligent Key contains the mechanical key.

To remove the mechanical key, release the lock knob on the back of the Intelligent Key.

To install the mechanical key, firmly insert it into the Intelligent Key until the lock knob returns to the lock position.

Use the mechanical key to lock or unlock the driver’s door.

CAUTION

Always carry the mechanical key installed in the Intelligent Key slot.

See “Doors” in this section.

Keys
Remote keyless entry keyfob (if so equipped) Integrated door lock keyfob Key number plate CAUTION Do not leave the ignition key inside the vehicle when you leave the vehicle. A key num ...

NISSAN Vehicle Immobilizer System keys
You can only drive your vehicle using the master keys which are registered to the NISSAN Vehicle Immobilizer System components in your vehicle. These keys have a transponder chip in the key head ...

Other materials:

Glove box assembly
Removal and Installation REMOVAL Remove the instrument side finisher RH using a suitable tool. Remove the glove box assembly upper screws (A). Remove the glove box assembly lower screws (A). Disconnect the harness connectors from the trunk switch and glove box lamp, the ...

Steering wheel turning force is heavy or light
Description Steering wheel turning force is heavy or light. Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS With CONSULT Turn the ignition switch OFF to ON. Perform EPS self-diagnosis. Is any DTC detected? YES >> Check the DTC. Refer to STC-14, "DTC Index". NO & ...

Body side trim
Exploded View Rear body side welt Front body side welt Tether clip Front pillar finisher Metal clip Dash clip Dash side finisher Harness protector Front kicking plate inner Center pillar lower finisher Rear kicking plate inner Cap Center pillar upper finisher Rear p ...

© 2014-2025 Copyright www.nisentra.com