Nissan Sentra manuals

Nissan Sentra Service Manual: Mixture ratio self-learning value clear

Nissan Sentra Service Manual / Engine / Engine control system / Basic inspection / Mixture ratio self-learning value clear

Description

This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”.

Work Procedure

1.START

With CONSULT


  1. Start engine and warm it up to normal operating temperature.
  2. Select “SELF-LEARNING CONT” in “WORK SUPPORT” mode of “ENGINE” using CONSULT.
  3. Clear mixture ratio self-learning value by touching “CLEAR”.

With GST


  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF.
  3. Disconnect mass air flow sensor harness connector.
  4. Restart engine and let it idle for at least 5 seconds.
  5. Stop engine and reconnect mass air flow sensor harness connector.
  6. Select Service $03 with GST. Make sure DTC P0102 is detected.
  7. Select Service $04 with GST to erase the DTC P0102.

>> END

Idle air volume learning
Description Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps each engine idle speed within the specific range. It must be performed under any of the following ...

Fuel pressure
Work Procedure FUEL PRESSURE RELEASE 1.FUEL PRESSURE RELEASE With CONSULT Turn ignition switch ON. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINEР...

Other materials:

Low tire pressure warning lamp does not turn on
Low Tire pessure Warning Lamp Does Not Come On When Ignition Switch Is Turned On Note: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS transmitter IDs Display t ...

DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT Description CAN (Controller Area Network) is a serial communication system for real time application. It is an on-vehicle multiplex communication system with high data communication speed and excellent error detection ability. Many electronic control units are equip ...

System
SRS air bag system SRS AIR BAG SYSTEM : System Diagram SRS AIR BAG SYSTEM : System Description The air bag deploys if the air bag diagnosis sensor unit is activated while the ignition switch is in the ON or START position. The collision modes for which supplemental restraint systems ...

© 2014-2024 Copyright www.nisentra.com