Nissan Sentra Owners Manual: Manual control
While using the voice recognition system, it is possible to select menu options by using the steering wheel controls instead of speaking voice commands. This can be especially helpful if the noise of driving makes it difficult for the voice recognition system to accurately interpret commands.
The manual control mode does not allow
dialing a phone number by digits. The user may
select an entry from the Phonebook or Recent
Calls lists. To re-activate voice recognition, exit
the manual control mode by pressing and holding
the PHONE/END ( 
) button. At that
time,
pressing the PHONE/SEND ( 
) button
will
start the Hands Free Phone System.
Operating tips
- To enter manual control mode, start the
voice recognition system and tilt the tuning
(
) switch up or down. The
system will speak Showing Manual Options when manual controls are initially activated. - To browse the menu options, tilt the tuning
(
) switch up or down. The
system will always speak the current menu option. Depending on the audio display, it will also show the current menu option. - To select the current menu option, press the
PHONE/SEND (
) button. - To go back to the previous menu, press the
PHONE/END (
) button. If the
current menu is the Main Menu, pressing the PHONE/END (
) button will exit
the Phone system. - To exit the manual control mode, press and
hold the PHONE/END (
) button
for 5 seconds
Voice Adaptation (VA) mode
Voice Adaptation allows up to two out-of-dialect
users to train the system to improve recognition
accuracy. By repeating a number of commands,
the users can create a voice model of their own
voice ...
Troubleshooting guide
The system should respond correctly to all voice
commands without difficulty. If problems are encountered,
try the following solutions.
Where the solutions are listed by number, try
each solutio ...
Other materials:
Encoder
Driver side
DRIVER SIDE : Description
Detects condition of the front power window motor lh operation and transmits
to main power window and door
lock/unlock switch as pulse signal.
DRIVER SIDE : Component Function Check
1. Check encoder operation
Check front door glass lh perform auto open ...
P2122, P2123 APP Sensor
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P2122 or P2123 is displayed with DTC P0643, first perform the
trouble diagnosis for DTC P0643.
Refer to EC-353, "DTC Logic".
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible caus ...
Drive belt
Automatic tensioner
Generator
Water pump
Air conditioner compressor
Crankshaft pully
WARNINGBe sure the ignition switch is in the OFF
or
LOCK position before servicing drive belt.
The engine could rotate unexpectedly.
Visually inspect the belt for signs of ...
