Nissan Sentra Service Manual: Main power window and door lock/ unlock switch
Removal and Installation
REMOVAL
- Release the pawls using a suitable tool and lift the main power window and door lock/unlock switch and finisher as an assembly and remove.
- Disconnect the harness connector from the main power window and door lock/unlock switch.
- Release the four pawls (two on each side) using a suitable tool, then separate the main power window and door lock/unlock switch (1) from the main power window and door lock switch finisher (2).
: Pawl
CAUTION:
Do not bend back the pawls on the switch finisher too far or breakage may occur.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
When the main power window and door lock/unlock switch is disconnected from the harness connector it is necessary to perform the initialization procedure. Refer to PWC-29, "Work Procedure".
Power window and door lock/unlock switch RH
Removal and Installation
REMOVAL
Release the pawls using a suitable tool and lift the power window and
door lock/unlock switch RH and finisher
as an assembly and remove.
Disconnect the har ...
Other materials:
System description
Component parts
CVT CONTROL SYSTEM
CVT CONTROL SYSTEM : Component Parts Location
No.
Component
Function
1
ECM
Mainly transmits the following signal to TCM via CAN
communication.
Engine and CVT integrated control signal
NOTE:
General term for the c ...
Pedal vibration or abs operation
sound occurs
Diagnosis Procedure
CAUTION:
Under the following conditions, ABS is activated and
vibration is felt when brake pedal is lightly
depressed (just place a foot on it). However, this is normal.
When shifting gears
When driving on slippery road
During cornering at high spee ...
Performance test
Inspection
INSPECTION PROCEDURE
Connect recovery/recycling/recharging equipment (for HFC-134a) or
manifold gauge.
Start the engine, and set to the following condition.
Test condition
Maintain test condition until A/C system becomes stable. (Approximately
10 minutes)
Check t ...
