Nissan Sentra Service Manual: Main line between dlc and hvac circuit
Diagnosis procedure
1.Check harness continuity (open circuit)
- Turn the ignition switch off.
- Disconnect the battery cable from the negative terminal.
- Disconnect the following harness connectors.
- Ecm
- A/C auto amp.
- Check the continuity between the data link connector and the A/C auto amp. harness connector.
Is the inspection result normal? Yes (present error)>>check can system type decision again.
Yes (past error)>>error was detected in the main line between the data link connector and the a/c auto amp.
No >> repair the main line between the data link connector and the a/c auto amp.
Main line between ipdm-e and dlc
circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and ...
Ecm branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the ECM for damage, bend and ...
Other materials:
P0117, P0118 ECT Sensor
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0117
ECT SEN/CIRC
(Engine coolant temperature
sensor 1 circuit low)
An excessively low voltage from the engine
coolant temperatu ...
Hvac branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal
Check the terminals and connectors of the a/c auto amp. For damage, bend
and loose connection (unit
side and connector side).
Is the inspection result normal?
...
Front fog lamp
Aiming adjustment
PREPARATION BEFORE ADJUSTING
The fog lamp is a semi-sealed beam type which uses a replaceable halogen
bulb. Before performing aiming
adjustment procedure, check the following:
Ensure all tires are inflated to correct pressure.
Place vehicle and screen on level surface.
...
