Nissan Sentra Service Manual: Main line between dlc and av circuit
Diagnosis procedure
1.Check harness continuity (open circuit)
- Turn the ignition switch off.
- Disconnect the battery cable from the negative terminal.
- Disconnect the following harness connectors.
- ECM
- AV control unit
- Check the continuity between the data link connector and the av control unit harness connector.
- With navigation system and bose audio system
- With navigation system without BOSE audio system
Is the inspection result normal? YES (Present error)>>Check CAN system type decision again.
YES (Past error)>>Error was detected in the main line between the data link connector and the AV control unit .
NO >> Repair the main line between the data link connector and the AV control unit.
Main line between ipdm-e and dlc circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and ...
Ecm branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the ECM for damage, bend and ...
Other materials:
Removal and installation
Nats antenna amp
Removal and installation
Removal
Remove instrument finisher b. Refer to ip-14, "exploded view".
Using a suitable tool release the pawls on either side and remove the
NATS antenna amp. from the pushbutton
ignition switch.
Installation
Installation is in the ...
Tires
Replace or rotate tires in accordance with maintenance schedules
and treadwear.
Checking tires
Check if the treadwear indicators are showing on the tires. Also check
the tires for uneven wear, such as excessive wear on one side of the
tread.
Check the spare tire condition and pressure if not ...
P014C, P014D, P015A, P015B A/F Sensor 1
DTC Logic
DTC DETECTION LOGIC
To judge the malfunction of A/F sensor 1, this diagnosis measures response
time of the A/F signal computed
by ECM from the A/F sensor 1 signal. The time is compensated by engine operating
(speed and load), fuel
feedback control constant, and the A/F sensor 1 tem ...
