Nissan Sentra Service Manual: Low tire pressure warning lamp does not turn on
Low Tire pessure Warning Lamp Does Not Come On When Ignition Switch Is Turned On
Note:
The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
- Activate and display TPMS transmitter IDs
- Display tire pressure reported by the TPMS transmitter
- Read TPMS DTCs
- Register TPMS transmitter IDs
DIAGNOSTIC PROCEDURE
1.PERFORM SELF DIAGNOSTIC RESULT
Perform “SELF DIAGNOSTIC RESULT”.
Is DTC “U1000” detected? YES >> Malfunction in CAN communication system. Refer to LAN-16, "Trouble Diagnosis Flow Chart".
NO >> GO TO 2
2.CHECK COMBINATION METER
Check combination meter operation. Refer to MWI-17, "CONSULT Function (METER/M&A)".
Is the inspection result normal? YES >> GO TO 3
NO >> Replace combination meter. Refer to MWI-77, "Removal and Installation".
3.CHECK LOW TIRE PRESSURE WARNING LAMP
Disconnect BCM harness connector.
Does the low tire pressure warning lamp activate? YES >> Replace BCM. Refer to BCS-73, "Removal and Installation" (With Intellingent Key System) or BCS-126, "Removal and Installation" (Without Intellingent Key System).
NO >> Check combination meter operation.
Low tire pressure warning lamp
Symptom Table
Low tire pressure warning lamp symptom chart
Note:
If tire pressure sensor wake-up operation is not completed for two or more
tire pressure sensors, the applicable
low tire ...
Low tire pressure warning lamp does not turn oFF
Low Tire Pressure Warning Lamp Stays On When Ignition Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.INSPECT BCM CONNECTOR
Turn ignition switch OFF.
Disconnect BCM connectors.
Check terminals fo ...
Other materials:
Normal operating condition
Description
Symptom
Result
Slight vibrations are felt on the brake pedal and operation noises
occur when VDC, TCS or ABS is activated.
This is a normal condition
due to the VDC,
TCS or ABS activation.
Stopping distance is longer than that of vehicles without ...
Periodic maintenance
Road wheel
Inspection
ALUMINUM WHEEL
Check tires for wear and improper inflation.
Check wheels for deformation, cracks and other damage. If deformed,
remove wheel and check wheel
runout.
Remove tire from aluminum wheel and mount wheel on a balancer machine.
Set dial indicator as ...
Brakes
If the brakes do not operate properly, have the
brakes checked by a NISSAN dealer.
Self-adjusting brakes
Your vehicle is equipped with self-adjusting
brakes.
The front (and rear– if so equipped) disc-type
brakes self-adjust every time the brake pedal is
applied. The rear drum-type brakes ...
