Nissan Sentra Service Manual: Low tire pressure warning lamp
Component Function Check
1.CHECK THE ILLUMINATION OF THE LOW TIRE PRESSURE WARNING LAMP
Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is turned ON.
Is the inspection result normal? YES >> Inspection End.
NO >> Perform trouble diagnosis. Refer to WT-33, "Diagnosis Procedure".
Diagnosis Procedure
1.PERFORM SELF DIAGNOSTIC RESULT
With CONSULT
- Turn the ignition switch ON.
- Perform “SELF DIAGNOSTIC RESULT”.
Are any DTCs detected? YES >> Refer to BCS-49, "DTC Index" (with Intelligent Key system) or BCS-109, "DTC Index" (without Intelligent Key system).
NO >> GO TO 3.
2.CHECK LOW TIRE PRESSURE WARNING LAMP SIGNAL
With CONSULT
- Turn the ignition switch ON.
- On “DATA MONITOR” select “WARNING LAMP.”
- Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is turned ON.
Is the inspection result normal? YES >> Check the combination meter. Refer to MWI-17, "CONSULT Function (METER/M&A)".
NO >> Replace the BCM. Refer to BCS-73, "Removal and Installation" (with Intelligent Key system) or BCS-126, "Removal and Installation" (without Intelligent Key system).
C1729 Vehicle speed signal
DTC Logic
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS ...
Power supply and ground circuit
WITH INTELLIGENT KEY SYSTEM
WITH INTELLIGENT KEY SYSTEM : Diagnosis Procedure
Regarding Wiring Diagram information, refer to BCS-51, "Wiring Diagram".
1.Check fuses and fusible link
Chec ...
Other materials:
Precaution for work
When removing or disassembling each component, be careful not to damage
or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
When removing (disengaging) components with a screwdriver or similar
tool, be sure to wrap the component
with a ...
Parking lamp circuit
Description
The ipdm e/r (intelligent power distribution module engine room) controls the
tail lamp relay based on inputs
from the bcm over the can communication lines. When the tail lamp relay is
energized, power flows through
fuse 36, located in the ipdm e/r. Power then flows to the front ...
TCM
Exploded View
Bracket
TCM
: Vehicle front
: NВ·m (kg-m, in-lb)
Removal and Installation
CAUTION:
When replacing TCM, note the “CVTF DETERIORATION DATE” value
displayed on CONSULT “CONFORM
CVTF DETERIORTN” in MAINTENANCE BOOKLET, before start the opera ...
