Nissan Sentra manuals

Nissan Sentra Owners Manual: Loading tips

Nissan Sentra Owners Manual / Technical and consumer information / Vehicle loading information / Loading tips

WARNING

  • Properly secure all cargo with ropes or straps to help prevent it from sliding or shifting. Do not place cargo higher than the seatbacks.

    In a sudden stop or collision, unsecured cargo could cause personal injury.

  • Do not load your vehicle any heavier than the GVWR or the maximum front and rear GAWRs.

    If you do, parts of your vehicle can break, tire damage could occur, or it can change the way your vehicle handles. This could result in loss of control and cause personal injury.

  • Overloading not only can shorten the life of your vehicle and the tire, but can also cause unsafe vehicle handling and longer braking distances. This may cause a premature tire failure which could result in a serious accident and personal injury. Failures caused by overloading are not covered by the vehicle’s warranty.
Vehicle load capacity
Do not exceed the load limit of your vehicle shown as “The combined weight of occupants and cargo” on the Tire and Loading Information label. Do not exceed the number of occupants shown as ...

Measurement of weights
Secure loose items to prevent weight shifts that could affect the balance of your vehicle. When the vehicle is loaded, drive to a scale and weigh the front and the rear wheels separately to determ ...

Other materials:

Heater operation
This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and the side vent outlets. Press the button to the OFF position for normal heating. Press the air flow control button. Turn the fan control dial to the desired position. Tur ...

Hvac branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the a/c auto amp. For damage, bend and loose connection (unit side and connector side). Is the inspection result normal? ...

Liquid Gasket
REMOVAL OF LIQUID GASKET SEALING After removing the bolts and nuts, separate the mating surface and remove the liquid gasket using Tool (A). Tool Number : KV10111100 (J-37228) CAUTION: Be careful not to damage the mating surfaces. In areas where the cutter is difficult to use, use ...

© 2014-2025 Copyright www.nisentra.com