Nissan Sentra Service Manual: Lan system

Removal and installation

Bcm (body control module) Removal and Installation Note: Before replacing bcm, perform “read configuration” to save or print current vehicle specification. Refer to bcs-116, "conf ...

Can fundamental

...

Other materials:

P0037, P0038 HO2S2 Heater
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0037 HO2 HTR (B1) (HO2S heater control circuit low bank 1 sensor 2) The current amperage in the heated oxygen sensor 2 heater ci ...

BCM  branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the bcm for damage, bend and loose connection (unit side and connector side). Is the inspection result normal? Yes > ...

Front disc brake
Exploded View Cap Bleeder valve Cylinder body Piston seal Piston Piston boot Upper sliding pin Lower sliding pin Sliding pin boot Bushing Torque member Apply brake fluid Apply rubber grease Disassembly and Assembly DISASSEMBLY Place a wooden block as shown, and ...