Nissan Sentra manuals

Nissan Sentra Service Manual: Key interlock cable

Exploded View


  1. Shift selector assembly
  2. Clip
  3. Key interlock cable
  4. Clip
  5. Key cylinder

Removal and Installation

REMOVAL

CAUTION:

Always apply the parking brake before performing removal and installation.

  1. Remove the steering column cover, and the instrument lower panel LH. Refer to IP-21, "Removal and Installation".
  2. Remove the center console assembly. Refer to IP-17, "Removal and Installation".
  3. Press the pawls (B) of the key interlock cable slider (A) while sliding it in the direction of the casing cap (C), and separate the adjusting holder (D) and slider.

(E) :Key interlock rod

  1. Remove the key interlock cable from the shift selector.


  1. Lift the clip (A) in the direction of the arrow ([C]) and remove
    [C]) and remove in the direction of the arrow ([D]).
    [D]).

(1) : Key interlock cable

(B) : Key cylinder

  1. Remove the key interlock cable from the key cylinder.
  2. Disengage the clip and disconnect the key interlock cable from the vehicle.

INSTALLATION


INSTALLATION

  1. Move the shift selector to P position.
  2. Turn the ignition switch to ACC or ON position.
  3. Install the holder of key interlock cable to key cylinder.
  4. Install the clip (A) in the direction of the arrow ([C]) and push it
    [C]) and push it in the direction of the arrow ( [

    D]).


(1) : Key interlock cable

(B) : Key cylinder

  1. Turn the ignition switch to LOCK position.


  1. Install the adjusting holder (A) onto the key interlock rod (B), then install the casing cap (C) onto the shift selector cable bracket (D).

CAUTION:


  1. While pressing the detent rod (B) down, slide the key interlock cable slider (A) toward the key interlock rod (D) side and install the adjusting holder (C) and key interlock rod.

CAUTION:

  1. Install the center console assembly. Refer to IP-17, "Removal and Installation".
  2. Install the steering column cover, and the instrument lower panel LH. Refer to IP-21, "Removal and Installation".

Inspection


Inspection

INSPECTION AFTER INSTALLATION

Control cable
Exploded View Control cable Lock plate Transaxle assembly Bracket A Bracket B CVT shift selector assembly Manual lever Grommet Removal and Installation INSTALLATION CA ...

TCM
Exploded View Bracket TCM : Vehicle front : N·m (kg-m, in-lb) Removal and Installation CAUTION: When replacing TCM, note the “CVTF DETERIORATION DATE” value displ ...

Other materials:

P2138 APP Sensor
DTC Logic DTC DETECTION LOGIC NOTE: If DTC P2138 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to EC-353, "DTC Logic". DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause ...

Loading tips
The GVW must not exceed GVWR or GAWR as specified on the F.M.V.S.S./C.M.V.S.S. certification label. Do not load the front and rear axle to the GAWR. Doing so will exceed the GVWR. WARNING Properly secure all cargo with ropes or straps to help prevent it from slid ...

Diagnosis system (bcm)
Common item Common item : consult function (bcm - common item) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. Direct Diagnostic Mode Description ECU identification The BCM part number is displayed. Self Diagnostic Result ...

© 2014-2024 Copyright www.nisentra.com